Exterior (external body elements) of the car Honda Fit/Jazz 1

Removal and installation of a forward bumper
Front bumper. 1 - clamp, 2 - body, 3 - side sleeve, 4 - fender liner, 5 - fog lamp connector (models with fog lights), 6 - mudguard, 7 - front bumper, 8 - lower bumper pad, 9 - limiter. 1. Disconnect a wire from the...

Removal and installation of a back bumper
Rear bumper. 1 - clamp, 2 - side bushing, 3 - side bracket, 4 - rear bumper, 5 - lower bumper pad. 1. Disconnect a wire from the negative plug of the storage battery. 2. When removing the rear bumper and the lower...

Removal and installation of a ventilating lattice of a cowl
1. Remove the levers and wiper blades (see chapter " Body electrical equipment "). 2. Remove the rear seal (A) hood. Disconnect the three pistons. Note: when removing and installing, be careful not to damage the...

Hood — adjustment
Horizontal Gap Adjustment Loosen the hinge bolts (IN) to the body (see picture "Hood adjustment") and adjust the clearance. After adjustment, tighten the mounting bolts. Tightening torque - 9.8 Nm After adjustment,...

Removal and installation of a cowl
1. Disconnect a wire from the negative plug of the storage battery. 2. Remove the protective screen. A) Disconnect the windshield washer hose (see section " Removal and installation of a ventilating lattice of a cowl...

Removal and installation of a fender liner
1. When removing and installing the fender liner, follow the assembly drawings "Left fender liner" And "Right fender liner". Left fender liner Right fender liner 2. Loosen the screws. 3. (Left fender liner) Remove the...

Removal and installation of a lateral rear-view mirror
Side and interior rearview mirror. 1 - side mirror housing, 2 - side mirror, 3 - locking bolt, 4 - lock washer, 5 - support, 6 - holder, 7 - interior mirror, 8 - cover. Note: Installation is in the reverse order of...